Watch how to use Mike’s Spike Anchors for Umbrella Installation

Click the link below to see how to use the Mike’s Spike Anchor properly.

  1.  Pound into the sand, approximately 10 inches, to the ‘ring’.
  2.  Pull anchor out and sling sand out of of tube.
  3.  Pound anchor into the sand 3 or 4 times to ‘seat’ the anchor into the sand.
  4.   Place umbrella into the anchor and then ‘snug’ tighten only the thumbscrew.
  5.   DO NOT attempt to install anchor while attached to umbrella.
  6.   Failure to follow these directions can break the anchor and that’s a $50 charge to your card.